OWNER’SMANUAL100 ATRTMBOLT ACTIONCENTERFIRE RIFLEIMPORTANT “SAFETY WARNINGS” — NOTE THE SYMBOLTHESE SAFETY WARNINGS ARE FOR YOUR PROTECTION AS WELL AS
8The bolt can be removed from the barreled action, and the barreled action can beremoved from the stock, but further disassembly should be performed b
9SERVICE INSTRUCTIONSShould your firearm, or any component of your firearm require service, kindly shipyour entire firearm (please do not send compone
10MOSSBERG WARRANTY100 ATRTMBOLT ACTION RIFLEONE (1) YEAR LIMITED WARRANTYLimited Warranty: O.F. Mossberg & Sons, Inc. (“Mossberg”) warrants to yo
11NOTES65148_Eng 6/27/08 8:25 AM Page 11
12NOTES65148_Eng 6/27/08 8:25 AM Page 12
13NOTES65148_Eng 6/27/08 8:25 AM Page 13
14100 ATRTMPARTS LISTITEM DESCRIPTION ITEM DESCRIPTION1* RECEIVER 18 EJECTOR PIN2 BOLT STOP 19 EXTRACTOR3 BOLT STOP SCREW 20 EXTRACTOR DETENT BALL4 BO
1565148_Eng 6/27/08 8:25 AM Page 15
From the time an individual picks up a firearm, that individual shooter becomesa part of a system over which he has complete control. He is the only p
PART NO. 17100REV. CAs the owner of a firearm, you must undertake the full-time responsibilityof safe firearms handling for your own safety and the sa
TABLE OF CONTENTSPageUnpacking Your New Bolt Action Rifle ... 2The Mechanical Safety ...
OPERATING INSTRUCTIONSRead and understand this entire manual and its safety warnings beforehandling this firearm.UNPACKING YOUR NEW BOLT ACTION RIFLE
The mechanical safety lever of your Mossberg firearm works directly with the trigger assembly. For this reason, the trigger mechanism is permanently s
C. Push the bolt fully forward and rotate the bolt handle clockwise and down tothe “closed bolt” position. Observe the end of the bolt. The round flat
Do not load firearm until ready for use! Unload firearm when shooting hasbeen completed! The safety lever should always be in the “ON” (SAFE)position
your thumb while slowly sliding the bolt forward so that it overrides the top cartridgein the magazine. Keeping the muzzle pointed in a safe direction
7After unloading always visually and physically inspect the chamberand magazine to make sure that all of the cartridges have beenremoved.TO REMOVE BOL
Kommentare zu diesen Handbüchern